Replacement Thermocouple For Patio Heater

A thermocouple is a device that converts heat into electricity. It is commonly used in patio heaters to measure the temperature of the flame. Over time, thermocouples can become faulty and need to be replaced.

Replacing a thermocouple is a relatively simple process that can be completed in a few minutes. However, it is important to follow the instructions carefully to ensure that the thermocouple is installed correctly.

Tools and Materials Needed

Replacement thermocouple
Wrench
Screwdriver
Electrical tape

Instructions

1. Turn off the gas supply to the patio heater.

2. Remove the front panel of the patio heater. This is typically held in place by a few screws.

3. Locate the thermocouple. It is usually located near the burner.

4. Disconnect the wires from the thermocouple. These wires are typically held in place by a small screw.

5. Unscrew the thermocouple from the patio heater.

6. Install the new thermocouple. Tighten the screw to secure it in place.

7. Connect the wires to the thermocouple. Tighten the screw to secure them in place.

8. Reinstall the front panel of the patio heater.

9. Turn on the gas supply to the patio heater.

10. Test the thermocouple by lighting the patio heater. The thermocouple should generate a voltage that will cause the gas valve to open.

Tips

When selecting a replacement thermocouple, it is important to choose one that is compatible with your patio heater.
Be careful not to overtighten the screws when installing the thermocouple.
If you are not comfortable replacing the thermocouple yourself, you can contact a qualified technician.