How To Clean Patio Paving

Patio paving can become dirty and stained over time, but it is possible to clean it and restore its original appearance. There are a few different methods that can be used, depending on the type of paving and the severity of the dirt and stains.

For light dirt and stains, a simple solution of water and dish soap can be used. Mix 1/4 cup of dish soap into a gallon of water and apply it to the paving with a brush or sponge. Scrub the paving in a circular motion and then rinse it off with clean water.

For more stubborn dirt and stains, a stronger cleaning solution may be necessary. A mixture of equal parts water and white vinegar can be used to remove grease and oil stains. Apply the solution to the stain and let it sit for 10 minutes. Scrub the stain with a brush and then rinse it off with clean water.

Bleach can also be used to remove stains from patio paving, but it is important to use it carefully as it can damage the paving if it is not diluted properly. Mix 1 cup of bleach into a gallon of water and apply it to the stain. Let it sit for 10 minutes and then scrub the stain with a brush. Rinse the paving thoroughly with clean water.

If the dirt and stains are particularly stubborn, a pressure washer can be used to remove them. Be sure to use a low pressure setting and hold the nozzle at a distance of at least 12 inches from the paving. Start by spraying the paving in a small area to test the pressure and then gradually increase the pressure as needed.

Once the paving has been cleaned, it is important to seal it to protect it from future dirt and stains. A good quality sealer will help to keep the paving looking its best for years to come.