Andersen Patio Door Hardware Replacement

Andersen patio door hardware replacement is a relatively straightforward process that can be completed in a few hours with the right tools and materials. By following these step-by-step instructions, you can easily replace the hardware on your Andersen patio door and restore its functionality.

Materials You'll Need:

New Andersen patio door hardware kit
Phillips head screwdriver
Flathead screwdriver
Hammer
Safety glasses

Step 1: Remove the Old Hardware

Begin by removing the old hardware from the patio door. Use a Phillips head screwdriver to remove the screws that hold the handle in place. Once the handle is removed, use a flathead screwdriver to pry the lock cylinder out of the door. Finally, remove the strike plate from the door frame using a hammer and chisel.

Step 2: Install the New Handle

To install the new handle, simply reverse the steps you took to remove the old handle. Insert the handle into the door and align the screw holes. Secure the handle in place with the screws provided in the hardware kit.

Step 3: Install the New Lock Cylinder

To install the new lock cylinder, insert it into the door and align the keyhole with the hole in the strike plate. Use a hammer to tap the lock cylinder into place until it is flush with the door. Be careful not to hit the lock cylinder too hard, as this could damage it.

Step 4: Install the New Strike Plate

To install the new strike plate, hold it in place on the door frame and align the screw holes. Secure the strike plate in place with the screws provided in the hardware kit. Be sure to tighten the screws securely.

Step 5: Test the New Hardware

Once the new hardware is installed, test it to make sure it is working properly. Open and close the door a few times to make sure the handle and lock are functioning smoothly. You should also try locking and unlocking the door to make sure the lock cylinder is working properly.

Additional Tips:

If you are having difficulty removing the old hardware, you may need to use a penetrating oil to loosen the screws.
Be careful not to overtighten the screws when installing the new hardware, as this could damage the door or the hardware.
If you are not comfortable replacing the hardware on your own, you can always contact a qualified professional for assistance.