Andersen Hinged Patio Door Adjustment

Andersen hinged patio doors are designed to last for many years, but even the highest-quality doors can eventually require adjustment. If your Andersen hinged patio door is not opening or closing properly, or if there is a draft coming in around the door, you can adjust it yourself with a few simple tools.

Tools You Will Need

Phillips head screwdriver
Flat head screwdriver
Allen wrench
Tape measure
Level

Adjusting the Hinges

The hinges on your Andersen hinged patio door are adjustable in three ways: up and down, side to side, and in and out. To adjust the hinges, follow these steps:

Locate the adjustment screws on the hinges. There are two adjustment screws on each hinge: one for up and down adjustment and one for side to side adjustment.
Use a Phillips head screwdriver to turn the adjustment screws clockwise to raise the door or move it to the right, or counterclockwise to lower the door or move it to the left.
Check the alignment of the door after each adjustment. The door should be level and should open and close smoothly.

Adjusting the Strike Plate

The strike plate is the metal plate that the door latch bolts into when the door is closed. If the strike plate is not properly aligned, the door may not latch properly or may be difficult to open. To adjust the strike plate, follow these steps:

Locate the strike plate on the door frame. The strike plate is typically attached to the door frame with two screws.
Use a Phillips head screwdriver to loosen the screws. Do not remove the screws completely.
Move the strike plate up or down as needed to align it with the door latch bolt. The strike plate should be positioned so that the door latch bolt engages with the strike plate without any binding.
Tighten the screws to secure the strike plate in place.

Adjusting the Weatherstripping

The weatherstripping on your Andersen hinged patio door helps to keep out drafts and moisture. Over time, the weatherstripping can become compressed or damaged, which can allow air and water to enter your home. To adjust the weatherstripping, follow these steps:

Inspect the weatherstripping around the door. Look for any gaps or tears in the weatherstripping.
If there are any gaps or tears in the weatherstripping, replace it with new weatherstripping. You can purchase new weatherstripping at most hardware stores.
To install new weatherstripping, simply peel off the backing and press the weatherstripping into place.

Tips for Adjusting Andersen Hinged Patio Doors

Always start by making small adjustments. It is easier to make small adjustments and gradually work your way to the desired result than it is to make large adjustments that may overshoot the mark.
Check the alignment of the door after each adjustment. The door should be level and should open and close smoothly.
If you are not comfortable adjusting the door yourself, you can call a qualified technician to do it for you.